Tarmac Laying Contractor in St Martin's

Tarmac Laying Contractors in St Martin's — what to expect

When it comes to tarmac driveways, overlays, paths and private road surfacing in St Martin’s, the work is all about getting the ground prep right before a single load of asphalt arrives. A typical job here starts with excavating soft ground and bringing in a well-graded MOT Type 1 sub-base, which is then compacted in layers using a vibrating plate or, for larger runs, a proper roller. Only after that base is solid does a reputable contractor move on to laying an AC 20 binder course, followed by an AC 10 surface course to give that smooth, dark finish that drains well and stands up to Kent’s damp winters. Many older drives in the CT1 area have settled or cracked over time, and rather than dig everything out, a plane and overlay is often the more practical route – the existing surface is milled down, a tack coat is applied to help the new layer bond, and fresh tarmac is laid over the top. Edge restraint kerbs are worth doing at the same time to keep the edges neat and stop the material from spreading, and if you need access from the road, a dropped kerb will have to be approved and installed by the local authority. Some homeowners also opt for a tar and chip finish for a more textured, low-maintenance surface, particularly on paths or shared drives. If you’re thinking about having this sort of work done around St Martin’s, it’s a good idea to get a few local contractors to look at the site and give you a clear quote – no pressure, just a sensible way to compare what’s on offer.